Overview
Light reflectance value, or LRV, is a number for how light or dark a finished colour is. It belongs to the colour and finish, not to the product, so each colour in a range has its own figure.
What the test measures
LRV is the proportion of visible light a surface reflects when lit from all directions. The scale runs from 0, a perfect black that absorbs all light, to 100, a perfect white that reflects all of it.
No real coating reaches either end. Black finishes read a few points above 0 and white finishes read well below 100.
How the test is carried out
The UK method is BS 8493. A sample of the cured finish is measured with a spectrophotometer fitted with an integrating sphere. The instrument reads the reflected light across the visible spectrum and reports it as a single value.
The sample has to be the real finish at its real sheen. Gloss level and surface texture both change how much light comes back.
How to read the result
| LRV | What it describes |
|---|---|
| Low | Dark colours. Most of the light landing on the surface is absorbed. |
| Middle | Mid tones. |
| High | Light colours. Most of the light is reflected back into the space. |
The figure is most useful as a difference between two surfaces. BS 8300-2, the code of practice for accessible buildings, says adjacent surfaces that need to contrast should generally differ by 30 LRV points or more. That applies to a floor against a wall, a door against its frame, or a marked walkway against the floor around it.
What it means in use
- Lighting. A floor with a high LRV reflects more of the light in the room. A dark floor absorbs it, and the space needs more lighting to reach the same level.
- Contrast. Line marking, step edges and hazard areas are easier to see when their LRV is well apart from the surface beside them.
- Heat. Outdoors, a dark colour generally absorbs more of the sun's energy than a light one, so the surface runs warmer.
What the result does not tell you
LRV describes a clean, new finish. Dirt, tyre marks and wear lower the figure of a light floor and can raise the figure of a dark one. Contrast planned on paper needs cleaning to keep it.
Two colours can share an LRV and still look different, because LRV measures lightness and not hue. A red and a green of the same LRV will not contrast for someone who cannot tell the two hues apart.
LRV is not a gloss reading. See Gloss Value for that.
On our product pages
Where a product has been tested, its page shows the result, the method and, where the method has one, the rating. Results published on this site come from internal testing to the stated method. They are given for technical reference and comparison.
If a figure you need is not shown, ask our technical team.


Share:
Adhesion (Pull-Off)
Gloss Value